Watch a well-cut interview with the sound off, then with it on. With sound, most of the cuts seem to vanish. A big reason is that picture and sound rarely change on the same frame. That offset is called a J-cut or an L-cut, and it's one of the easiest things you can add to a dialogue edit to make it feel finished.
Start with a straight cut
A straight cut, sometimes called a butt cut, changes picture and sound together. Shot A ends, shot B starts, and B's video and audio begin on the same frame. That's fine for action, comedy timing and music. In conversation it feels abrupt, because that isn't how we experience talking to people: we usually hear someone start speaking before we turn to look at them.
The J-cut: you hear it before you see it
In a J-cut the next shot's audio starts before its picture. We're still looking at shot A when shot B's sound begins. On the timeline it looks like the letter J, with the second clip's audio reaching back under the end of the first.
It works well when you're opening a new scene (hear the waves or the traffic a second before you see the place), when you cut to someone who's about to talk (their first words start over the previous shot and the picture follows, like turning your head), and when two takes don't quite match, since the early audio pulls attention away from the picture change.
The L-cut: you keep hearing it after you leave
An L-cut is the reverse. The current shot's audio carries on after the picture has moved to shot B. On the timeline it's an L: the first clip's audio stretches out under the start of the second.
This is the one you'll use constantly. Let the speaker finish the sentence while you cut to the listener's face, because the reaction is often stronger than the line. Keep the interviewee talking while you cut to what they're describing, which is how most documentary B-roll is laid in. Or let the sound of one moment hang over the first shot of the next scene so the transition feels gentler.
Making them in Premiere Pro
- Make a straight cut between the two clips.
- Hold Alt and click the audio of one clip to select it without its linked video, or turn off Linked Selection in the timeline toolbar.
- With the Rolling Edit tool (N), drag the audio edit point only: left for a J-cut, right for an L-cut. The sequence stays the same length.
Use a rolling edit here, not a ripple trim. A roll moves one edit point between two clips without shifting anything else on the timeline, so sync stays where it was.
Making them in DaVinci Resolve
- Make the straight cut first.
- Hold Alt and click the audio edit point to select just the audio side, or turn off Linked Selection with Ctrl+Shift+L.
- In Trim mode (T), drag the audio edit point left for a J-cut or right for an L-cut. Resolve rolls the edit and leaves everything else in place.
How long should the overlap be?
Shorter than you'd expect. In conversation, a few frames up to about a second is plenty; the viewer should feel the flow without noticing the trick. Scene changes and ambient sound can lead in or trail out for one to three seconds. If you catch yourself seeing the overlap on playback, pull it back.
Put a short crossfade where the two sounds meet so the level and the room tone don't bump. And if there's music under the dialogue, the music should dip with the voices, not with the picture cuts.
Where Anvil Panel comes in
J-cuts and L-cuts are creative calls, and no tool should make them for you. What a tool can do is clear away the repetitive work around them. On an interview edit with Anvil Panel, you'd line up the camera and recorder audio with Sync clips, take out the pauses and the "ums" with Silence cut and Filler-word cut, and dip the music under the speech with Auto-duck. In Premiere Pro, Auto-duck writes ordinary volume keyframes, so you can nudge them around your J- and L-cuts afterwards.
That leaves your time for the part that matters: shaping the overlaps, choosing the reactions and laying in the B-roll.